а√天堂中文官网在线bt,樱花草在线社区WWW韩国,免费国产a国产片高清,亚洲AV日韩精品久久久久

  What are the requirements for water pump maintenance and inspection?

For maintenance of the pump inspection, there are three key points,  the patrol inspection, inspection before

water pump start-up and during the operation.
Patrol inspection:
1) check the pump fuel tank oil level,  no jilt oil on both ends of oil casing when running.
2) check whether there is any leaking increase on pump glen.
3) check pump connecting flange, footing and gland have screw loosening or less.
(4) check the  abnormal sound and vibration status of water pump in the operation, check the bearings'

temperature, billiard disc is overheating or not, check the pressure and negative pressure of inlet and outlet

of water pump.
(2) before starting the pump: require operators firstly check whether the motor power is connected

well;Motor grounding should be good;Bolts should be no loose;Rotating parts should be flexible, no card

lag.Check the relevant position of the valve is properly, the water pump bearings' oil level and oil is normal,

meter pointer is correct.
(3) In the running of water pump: requirements of operation personnel regularly check the pump and motor

noise, vibration, bearing and motor temperature and lubrication situation is normal;Magnetic starter, knife

switches, all kinds of meter and automation components are without smoking, sparks and overheating.For

multistage axial channeling vane pump, it should be paid attention to checking dynamic status; If deep well

pump, it should be regularly checked the shaft rod without bending. If something happend as belowings, it

should be quickly make the pump stop running.
(1) the pump impeller burst;
(2) the  temperature of motor and the bearing rises rapidly, and exceed allowable values;
(3) water pump vibration or move too much, its amplitude and channeling momentum are more than

specified value;
(4)Breaking up of column pipe or absorb pipe.